Table of Contents
Advertisement
Transition Module Preparation and Installation
Signal Descriptions
I2C_CLK -
I2C_DATA -
5.5.5
10/100/1000BaseTx Connectors
Two 10/100/1000BaseTx RJ-45 connectors are located on the rear panel of the standard
version of the CPCI-6115-MCPTM to support Ethernet I/O from the CPCI-6115 SBC. The pin
assignments for these connectors are as follows:
Table 5-9 10BaseT/100BaseTx Connector Pin Assignments
Pin
1
2
3
4
5
6
7
8
5.5.6
COM1 And COM2 Connectors (MXP Version)
Four RJ-45 connectors are located on the panel of the MXP version of the CPCI-6115-MCPTM
to provide the interface to the COM1 and COM2 serial ports originating from the CPCI-6115
SBC. The CPCI-6115 only supports two serial ports, COM1 and COM2.
The COM1DIR jumper is a two position (three pin) jumper which controls the origin of the serial
port. In one position, COM1 from the CPCI-6115 is enabled (and thereby disabling it on the
CPCI-6115 front panel connector). In the other position, the connector is redirected to the PMC
I/O module 1. The COM2DIR jumper is a two position (three pin) jumper which controls the
origin of the serial port. In one position, COM2 from the CPCI-6115 is enabled. In the other
position, the connector is redirected to the PMC I/O module 2.
The pin assignments for this connector is as follows:
Table 5-10 COM1, COM2 Connector Pin Assignments
Pin
1
2
3
4
100
I2C Serial Clock for transition module EEPROM
I2C Serial Data for transition module EEPROM
Signal
MDIO0+
MDIO0-
MDIO1+
MDIO2+
MDIO2-
MDIO1-
MDIO3+
MDIO3-
Signal
DCD
RTS
GND
TXD
CPCI-6115 CompactPCI Single Board Computer Installation and Use (6806800A68D)
10/100/1000BaseTx Connectors
Advertisement
Table of Contents
