Task 3: Forward Subscribers For All Calls - NEC 2400 Integration Manual

Cut-to-Service

Task 3: Forward Subscribers for All Calls

Use this feature to forward subscribers for all calls to the INTUITY System. The
switch automatically transfers the call to the UCD group administered for
INTUITY service.
NOTE:
The subscriber's service feature class must contain call forward RNA
SFI=7. Dterm sets may have a function key for forward all calls (FKY=2).
Use the following instructions to forward all calls.
1. Using the subscriber telephone, lift the handset and listen for the dial tone.
2. Dial the access code or press the function key for forward all calls.
After you perform the action you hear a second dial tone.
3. Dial the main extension of the UCD group administered for INTUITY
System service.
You created the UCD main extension during the switch administration
process in Chapter 7 of this document. The switch now forwards all calls
to the ap plication UCD group, creating an integrated voice mail system.
4. Repeat steps 1 through 3 for each subscriber extension that uses the
INTUITY System.
When you complete the station administration for all subscribers, return to the
"Cut-to-Service" chapter in INTUITY System Software Installation, 585-310-140,
and complete the cut-to-service procedure.
10-4
Issue 2 December 1995
NOTE:
If you do not know the access code or the function key for forward
all calls, contact your switch administrator. The switch administrator
sets the codes and function keys during the initial setup of the
switch.