Table of Contents
Advertisement
USING YOUR COOKTOP
COOKTOP
SURFACE BURNERS
LIGHTING SURFACE
TO remove cooktop: When cool, first
BURNERS
remove grates and drip bowls, if
equipped.Grasp twofront burner wells
1. Placeutensil on burner grate.
and lift up.
2. Push inand turnknob tothe LITE po-
sition.
I
I
Followthe instructionsto the illustration
_
_
that matches the burners onyour range.
_1"
_
t
1 Uniburners and single burners are se-
cured in place during transportationwith
either a shipping screw or a spring clip.
i °ncethe
r°nge
's installed
these
may
be removed to allow quick and easy re-
moval of the burner.
One piece uniburner
.
•
.
the desired flame size.
As the burner heats and cools, you may
•
hearsounds of the metal expanding and
contracting. This is a normal operating
sound of the burner.
Burner grates must be properly posi-
tioned before cookin_o. D o not operate Allow burnerto cool. Lift cooktop. To re-
If flame should go out during a cooking
burners without a pan on the grate. The
move uniburner, lift up slightly and pull
operation, turn the burner off. IF GAS
porcelain finish may chip without a pan
out. Under no circumstances are bum-
to absorb the intense heat.
HAS
ACCUMULATED
AND
A
ers to be taken apart for cleaning.
STRONG GAS ODOR IS DETECTED,
Uniburner can be cleaned in the dish-
WAIT 5 MINUTES FOR THE GAS
When reinstalling square grates, place
washer.Burnerandburnertubemustbe
ODOR TO
DISAPPEAR BEFORE
indented sides together so straight
dry before use.
RELIGHTING BURNER.
sides are at front and rear.
You may hear a "popping" sound on LP
Standard single burner
gas when the surface burner is turned
A properly adjusted burner with clean
•
ports will light within a few seconds. On
l
natural gas, the flame will be blue with a
deeper blue inner core; there should be
no trace of yellow in the flame• A yellow
flame indicates an improper mixture of
air/gas• This wastes fuel, so have a
serviceman adjust the mixture if a yel-
Remove or support cooktop. Grasp
low flame occurs• On LP gas, some yel-
burner head and tilt to release tab from
low tipping is acceptable• This is normal
slot near ignitor.Lift up and toward back
and adjustment is not necessary.
of cooktop until air shutter end of burner
releases from valve•
--8--
Advertisement
Table of Contents
