Table of Contents
Advertisement
FEATURES
DIGITAL CLOCK AND
TIMER,
if equipped
If your range is equippedwith a digital
clock and timer, itwill either bedesign
I or design 2. Follow the instructions
for the illustration that matches the
clock on your range.
-DESIGN
1-
-DESIGN
2-
o_ocK
HZN
TZNER
TO SET A TIMING OPERATION FOR
LESS THAN ONE HOUR: Press and
hold MIN buttonuntil desiredtime ap-
pears in the display.Timer will immedi-
88:88 will flash in the display when
When range is first connectedto power ately begin countingdown as soon as
range is first connectedto power or if
orif poweris interrupted,12:00 willflash
the MIN buttonis released.
power is interrupted,
in the display.
TO SET A TIMING OPERATION FOR
TO SET CLOCK: Press and hold TO SET CLOCK: Slide switch up to
MORE THAN ONE HOUR: Press the
CLOCK SET button while turning MIN-
CLOCK position.
HOUR button. (1:59 will appear in the
UTE TIMER knob to the correct time-
of-day. MINUTE TIMER knob can be
display.) Select desired minutes by
turned in either direction.
Press and hold HOUR button until cer-
pressing and holding MIN button. Tim-
rect hour appears in the display,
ing will begin when button is released.
Two hours is the maximum timing that
TO SET MINUTE TIMER: Turn MIN-
can be set.
UTE TIMER knob to the right, to the de-
Press and hold MIN button until the cor-
sired time, up to 60:00 (1 hour). Timer
rect minutes appear in the display.
will begin counting down aftera few sec-
When time has lapsed, a continual beep
will sound. Slide switch to the CLOCK
onds delay. When time has lapsed, a
continual beepwill soundfor upto 2 min-
TO SET MINUTE TIMER: Slide switch
positionto stop beeps.]]me-of-day will
down to TIMER position. The timer will
reappear in the display.
utes.
automatically begin counting down from
1 hour in increments of one minute.
Press CLOCK SET button to stop beep
sounds. The correct time-of-day will re-
appear in the display.
HOUR
CLOOC
8 o:s9.1
Turn MINUTE TIMER knob to the left,
until 00:00 appears in the display. The
NIN
TINER
correct time-of-day will reappear in the
display after a few seconds delay.
(0:59) will be displayed as soon as the
switch is moved to the TIMER position.)
To check time-of-day during a timing
operation, press and hold CLOCK SET
button. Time will reappear in the display.
-4-
Advertisement
Table of Contents
