Device Control Block (Trackball) - Sony DVS-9000 User Manual

Device Control Block (Trackball)

The device control block is used for three-
dimensional transform operations using a
DME, for wipe pattern position setting, and
5 MENU button
a Region selection buttons
The operation mode allocated to the device
control block depends on the selection state
of the region selection buttons.
When the [M/E 1], [M/E 2], [M/E 3], and
[P/P] buttons are selected: This
enables the wipe pattern position
setting (positioner) operation mode in
the device control block. You can
select multiple buttons simultaneously.
When the [USER] button is selected: This
enables pattern position setting used
for color backgrounds.
When the [DME1] to [DME8] buttons
are selected: This enables the three-
68
Names and Functions of Parts of the Control Panel
1 Region selection buttons
M/E1 M/E2 M/E3 P/P USER
DME1 DME2 DME3 DME4
RUN
DME5 DME6 DME7 DME8
CTRL
LOCAL GLB
SRC TRGT
MENU
K1 K2
K3 K4
CB1 CB2
AXIS ASP LOC LOC ROT
LOC PERS SIZE XYZ POS
MAIN SUB ASP LOC RSZR
CLR
SHIFT WORK X Y Z
BUFR
2 Operating buttons
for VTR/disk recorder/frame memory clip
operation.
3 Trackball
DEV
RSZR
CTRL
CTR
4 Z-ring
dimensional transform operation mode
in the device control block.
Press a button, turning it on, to select a
DME channel. You can select multiple
buttons simultaneously.
The number of valid buttons depends
on the number of DME processor
channels installed.
When the [DEV] button is selected: This
enables the VTR/disk recorder/frame
memory operation mode in the device
control block. Each button functions as
follows.
(From upper left to right in the above
figure)