Sony DVS-9000 User Manual page 674

With ccp-8000 series center control panel

Hide thumbs Also See for DVS-9000:

Table of Contents

In the device control block (search dial module), there is no such a mode

selection button and you can directly select a device.

Buttens used when the VTR/disk recorder/frame memory

operation mode is enabled

DELAY: Press this button, turning it on, to enter a delay value from the

STB OFF (standby off): Press this button to switch to standby off mode. This

REC (record): Press this button at the same time as the [Y] button to start

STOP: Press this button to stop the tape, disk or frame memory clip.

START TC (start timecode): Press this button to set the timecode of the start

STOP TC (stop timecode): Press this button to set the timecode of the stop

Control of VTRs, Extended VTRs, and Disk Recorders

Device control block in the VTR/disk recorder operation mode (trackball module)

numeric keypad control block.

button cannot be used for frame memory clip operations.

recording. This button cannot be used for frame memory clip operations.

point at that time. The timecode of the start point is updated to the current

time each time this button is pressed.

When the device the operation applies to is a VTR/disk recorder, the start

point updated by the setting of the [MENU] button is as follows.

When the [MENU] button is On: start point of the timeline

When the [MENU] button is Off: start point of Cueup & Play

point at that time. The timecode of the stop point is updated to the current

time each time this button is pressed.

When the device the operation applies to is a VTR/disk recorder, the stop

point updated by the setting of the [MENU] button is as follows.