Makita BFR440 Instruction Manual page 7

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the bit
Loosen the thumb screws which secure the casing. Pull
out the casing in the direction of the arrow.
1
2
006813
Press the dust cover toward the plane bearing and pull
out the bit. If the dust cover cannot be moved as far as
the plane bearing, try it again after turning the bit slightly.
To install the bit, insert it into the socket while turning it
slightly. After installing, always make sure that the bit is
securely held in place by trying to pull it out.
1 2 3
006814
Installing screw strip
1
2
3
006804
1. Casing
2. Thumb screws
1. Bit
2. Dust cover
3. Plane bearing
1. Feeder box
2. Screw strip
3. Screw guide
7
1
006805
Insert the screw strip through the screw guide. Then
insert it through the feeder box until the first screw
reaches the position next to the driving position.
Removing screw strip
To remove the screw strip, just pull it out in the direction
of the arrow.
006806
If you depress the reverse button, you can pull out the
screw strip in the reverse direction of the arrow.
1
006807
Carry hook
The carry hook is convenient for temporarily hooking the
tool. It can be installed on either side of the tool.
When removing the carry hook, widen it by pressing its
right ends ON BOTH SIDES in the directions of arrow (1)
and raise it in the direction of the arrow (2).
1
2
1
1
006808
1. Driving position
1. Reverse button
1. Hook