Makita TW0200 003994 Instruction Manual page 7

ASSEMBLY
1
2
1. Socket
2. Anvil
1
1. Hook
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and inconsistent
fastening torque and/or damage to the bolt or nut.
Installing or removing socket
003998
CAUTION:
• Always be sure that the tool is switched off and
unplugged before installing or removing the socket.
Align the hole in the side of the socket with the detent pin on
the anvil and push it onto the anvil of the tool until it locks into
place. Tap it lightly if required.
To remove the socket, simply pull it off.
Hook
The hook is convenient for temporarily hanging the tool. This
can be removed without using a tool.This can be installed on
either side of the tool.
Installing and removing hook
004000
Expand the upper part of the hook in both directions and
remove it. To install the hook, follow the removal procedure
in reverse.
7