Bevel Cutting - Makita 4334D Instruction Manual

1
1. Base securing lever
1
2 3
1. Dent mark
2. Slot
3. Graduation
1
1. Starting hole
16

Bevel cutting

002754
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before tilting the base.
With the base tilted, you can make bevel cuts at any angle
between 0° and 45° (left or right).
Loosen the base securing lever and move the base so that
the dent mark in the motor housing is aligned with the slot in
the base.
Tilt the base until the desired bevel angle is obtained. The
002755
edge of the motor housing indicates the bevel angle by grad-
uations. Then tighten the base securing lever to secure the
base.
NOTE:
• Always remove the plastic cover (chip shield) from the
tool when you make bevel cuts using an optional rip
fence (guide rule) or circular guide.
Front flush cuts
002759
Loosen the base securing lever and slide the base all the
way back. Then tighten the base securing lever to secure the
base.
Cutouts
Cutouts can be made with either of two methods A or B.
A) Boring a starting hole
002765
For internal cutouts without a lead-in cut from an edge,
pre-drill a starting hole 12 mm (1/2") or more in diameter.
Insert the blade into this hole to start your cut.