Strain Relief Cable Clamps - Honeywell Marathon Reference Manual

Strain Relief Cable Clamps

Six Strain Relief Cable Clamps are located on the back of the vehicle dock, 3 on each side.
Equipment required: Phillips screwdriver, not supplied by Honeywell.
1. Remove the strain relief cable clamp from the back of the dock by turning the screw counterclockwise. Put the screw
aside in a safe location.
2. Slide the strain relief clamp over the cable.
3. Using a Phillips screwdriver and the screw that was removed, refasten the clamp holding the cable to the vehicle dock.
Do not stretch the cable. Leave enough slack in the cable to allow the cable to be connected and disconnected from the
Marathon vehicle dock easily when needed.
4. Continue in this manner until all cables are secured to the back of the vehicle dock.
3-12
Left Set Right Set