Statistics Interval; Authentication Timeout; Show Captive-Portal - D-Link DWL-8500AP Command Reference Manual

statistics interval

Use this command to configure the interval at which statistics are reported to the cluster
controller. The
15-3600 seconds.
Default
Format
Mode
Example:
The following shows an example of the command.
(Switch)(Config-CP) #statistics interval 200<cr>
no statistics interval
Use this command to set the statistics interval to the default value.
Format
Mode
Example:
The following shows an example of the command.
(Switch)(Config-CP) #no statistics interval<cr>

authentication timeout

This command configures the authentication timeout. If the captive portal user does not enter
valid credentials within this time limit, the authentication page needs to be served again in
order for the client to gain access to the network. The
timeout, which is a number in the range of 60-600 seconds.
Default
Format
Mode
no authentication timeout
This command configures sets the authentication timeout to the default value.
Format
Mode

show captive-portal

This command reports status of the captive portal feature.
Format
Mode
Administrative Mode Shows whether the CP is enabled.
variable is the reporting interval, which is a number in the range of
<interval>
120
statistics interval <interval>
Captive Portal Config Mode
no statistics interval <interval>
Captive Portal Config Mode
300
authentication timeout <timeout>
Captive Portal Config Mode
no authentication timeout
Captive Portal Config Mode
show captive-portal
Privileged EXEC
4 Wireless Commands
variable is the authentication
<timeout>
Captive Portal Global Commands 205