Selecting The Paper Feed Method - Canon ImageRunner 2545i Reference Manual

3
Specify the desired nonstandard paper size:
3
IMPORTANT
Make sure that the paper size setting is correct. If the paper size loaded on the stack
bypass and the paper size setting do not match, a paper jam may occur.
NOTE
• If you make a mistake when entering numbers, press [C] (Clear) ➞ enter the correct
numbers.
• When entering numbers in millimeters, you can also use
• To enter values in inches, press [Inch]. (See "Entering Values in Inches," on p. 3-7.)
• When entering the length in inches, an underbar (_) must be entered between integer
and fraction.
4
Press

Selecting the Paper Feed Method

You can set whether the printing speed is the priority for your job, or whether to print
on a specific side of the paper. This setting is useful when you want to make one- or
two-sided prints on preprinted paper (paper which has logos or patterns already
printed on it) without turning over the paper loaded in a paper source.
NOTE
The default settings are 'Speed' for all paper sources.
3-22
Specifying Common Settings
(Clear) on the control panel.
(Reset) to return to the top screen.
❑
Press [Size 1] or [Size 2].
You can register two kinds of
nonstandard paper sizes.
❑
Press [X] ➞ enter the length along the
horizontal axis of the paper using [-] or
[+].
The horizontal length can be set
between 148 mm and 432 mm.
❑
Press [Y] ➞ enter the length along the
vertical axis of the paper using [-] or [+].
The vertical length can be set between
99 mm and 297 mm.
❑
Press [OK].
Repeat this step to register or edit another
size of nonstandard paper.
- (numeric keys) and