Table of Contents
Advertisement
If any of the following error messages is displayed, first
check the power to the camera, and connection of input
signals (40-pin consistency, etc.), then consult with a
Sony service or sales representative.
CAM Com Error
Reason: Communication between this unit and the
Camcorder cannot be made.
PLD Config NG
Cause: Trouble has occurred in the PLD on the DPR
board.
ENC Config NG
Reason: The encoder cannot be initialized.
RF PLL Unlock
Reason: The PLL of the transmission module does not
lock.
Specifications
General
Power requirements 12 V DC
Current consumption
770 mA
Operating temperature
0°C to +40°C (+32°F to +104°F)
Storage temperature –20°C to +60°C
(–4°F to +140°F)
97 × 209 × 152 mm (w/h/d)
Dimensions
7
× 8
(3
/
8
Mass
1.2 kg (2 lb 10 oz), excluding antenna
RF block
Transmission freqeuncy range
2402 to 2474 MHz
(model available in USA and
Canada)
2402 to 2482 MHz
(model available in other countries)
Transmission center freqeuncy range
2406 to 2470 MHz
(model available in USA and
Canada)
2406 to 2478 MHz
(model available in other countries)
Occupied bandwidth
8 MHz
RF power output
36 mW
Antenna gain
4.0 dBi
Antenna directivity Omni-directional
Modulation
16QAM-OFDM, QPSK-OFDM
Input/output
DC IN
External DC input, 10.5 to 17 V DC
XLR 4-pin (male)
RF OUT
Special connector, 50 ohms
DC OUT
10.5 to 17 V DC (DC IN volatage),
300 mA
Control input: –60 dBm
SPARE
BNC type, 75-ohm input
Supplied accessories
Transmission antenna (1)
Operation Manual (1)
CD-ROM (1)
1
× 6 inches)
/
4
Specifications
19
Advertisement
Table of Contents
