Attaching To The Camcorder - Sony WLL-CA50 Operation Manual

The display will be automatically turned off if you do not
operate the transmitter in normal transmission mode for a
while.
To turn the display on again, press the DISPLAY button.
d TX ON (transmission start) button
Press to start transmission.
To terminate transmission, turn off the power of the
transmitter by setting the DC LINE switch to OFF.
e DC LINE switch
To turn the power to the unit ON/OFF.
This button has no effect on the Camcorder. Turn the
power to the Camcorder on and off on the Camcorder side.
f MENU knob
Use this knob for making menu settings, including
transmission frequency.
For details on menu operations, see "Menu Settings" on
page 15.
g RF OUT connector
Mount the supplied transmission antenna.
Note
Do not use any antenna other than the supplied one.
h DC OUT connector
To supply power to a portable tuner, such as the WRR-
861A/861B UHF Portable Diversity Tuner and to accept
signals from the portable tuner.
i DC IN connector
When operating the unit on AC power, connect to the AC
Adaptor (optional) using the DC output cable.
j Battery attachment
Attach an optional battery pack.
The AC-DN10 AC adaptor (optional) can also be attached
for AC operation.
When power is supplied to the DC IN connector, it has
priority.
k SPARE connector
To accept external SDI/ASI signals.
For details on the connection, consult your Sony dealer.
12

Attaching to the Camcorder

Attaching to the
Camcorder
When the cover has been attached to the back of the
Camcorder, first remove it.
1
Fit the connectors of the transmitter to the
corresponding receptacles on the Camcorder
downward to dock.
2
Tighten the screws on the top.