Table of Contents
Advertisement
Transmission
To start transmission
1
Turn on the Camcorder.
2
Set the DC LINE switch to ON to turn on the
transmitter.
3
Press the TX ON button.
Video shot with the Camcorder is immediately
transmitted.
To stop transmission
Set the DC LINE switch to OFF.
You can also set it to OFF with a menu operation.
18
Transmission / Error Messages
Error Messages
When an error is generated, one of the following error
messages is displayed.
Com Error
Cause: The communication with the WLL-RX55 was lost
although it had once been established.
Measures: Check that the condition of the transmission
from this unit to the WLL-RX55, and the UHF
condition from the WLL-RX55 to this unit.
Emission CW
Reason: CW has been selected with a menu operation.
Measures: Change the menu setting to OFDM. Or turn the
transmitter off, then turn it on again.
Low Battery
Reason: The power voltage is lower than the value
specified on the menu.
Measures: Replace the battery, or increase the power
voltage.
No Video
Reason: No video signal is detected.
Measures: Check the power to the Camcorder.
Or check the consistency between the transmitter and
the Camcorder.
NTSC
Reason: An NTSC signal being supplied although the
transmitter has been set for PAL use.
Measures: Use a Camcorder of the PAL system. Or
change the transmitter setting on this unit to NTSC.
PAL
Reason: A PAL signal being supplied although the
transmitter has been set for NTSC use.
Measures: Use a Camcorder of the NTSC system. Or
change the transmitter setting on this unit to PAL.
TX OFF
Reason: The transmitter is waiting for a trigger for
transmission.
Measures: Press the TX ON button to start transmission.
Backup Error
Reason: The settings when the power was turned off have
benn deleted.
Measure: Reset if necessary.
If this error occurs frequently, consult with a Sony
service or sales representative.
Advertisement
Table of Contents
