Setting The Menu Items - Sony WLL-CA50 Operation Manual

Normally use Fast mode. Interleaving has more effect
in the order of Fast, Run, and Walk for robust
transmission, but the system delay also increases in
this order.
Emission: Select the RF emission format. When OFF is
selected, no RF carrier will be emitted.
Scramble: Set a 3-digit scramble code, using the
submenu.
Note
Set the same value as the descramble code of the
WLL-RX50/RX55 receiver to be used in combination.
Setup menu
Item Submenu
Default Set —
Low Batt —
Video —
Spare —
TS Set PGM No.
PID video
PID audio
PID PMT
PID PCR
Default Set: Select Yes to return the menu items other
than the video system to their default settings.
Low Batt: Select the battery voltage at which an alarm
message is to be displayed.
Video: Select the video system.
Spare: Select the signal to be accepted with the SPARE
connector.
TS Set: Using the submenu, set the transmission
parameters.
Status menu
To check the statuses. No settings can be made with this
menu.
Item Submenu
PLD Version IF
DPR
Serial No. —
Sys Timer —
EL Timer —
PLD Version: The version of the PLD software of each
internal board is displayed.
Serial No.: The 6-digit serial number of this unit is
displayed.
16
Menu Settings
Values (default)
No, Yes (No)
10 to 11.5 V (10.5 V)
NTSC, PAL
SDI, ASI (SDI)
(0x0001)
(0x0100)
(0x0101)
(0x0200)
(0x0050)
Values (default)
x.xx
x.xx
xxxxxx
xxxxx H
xxxxx H
Sys Timer: The accumulated operating time of the system
is displayed.
EL Timer: The accumulated operating time of the EL
display is displayed.

Setting the Menu Items

1
Set the DC LINE switch to ON to turn on the
transmitter.
The display lights.
When it turns to the status indications (see page 11),
you can start the menu operation.
If the display is not on, press the DISPLAY button.
2
Press the MENU knob.
The corresponding menu appears on the display.
3
Turn the MENU knob to move the cursor (c) to the
item to be set.
Example:
* Wireless *
Mode: Standard
c Interleave: Fast
Emission
Scramble
4
Press the MENU knob.
The cursor (c) changes to a flashing question mark
(?).
Example:
* Wireless *
Mode: Standard
? Interleave: Fast
Emission
Scramble
5
Turn the MENU knob to display the desired value.
Example:
* Wireless *
Mode: Standard
? Interleave: Run
Emission
Scramble
To cancel the change
Press the CANCEL button. The status in step 3 is
restored.
: OFF
>>
: OFF
>>
: OFF
>>