Selection Of The Control Circuit; Selection Of The Program; Selection Of Day Of The Week And Cycle - Honeywell SDC Service Manual

Operation
5.2.2.1
5.2.2.2
5.2.2.3
56

Selection of the control circuit

After accessing the "Timeprograms" menu, the desired control
circuits can be selected with the input button
sequence:
• Direct heating circuit (HC)
• Mixed heating circuit 1 (MC-1)
• Mixed heating circuit 2 (MC-2)
• Hot-water circuit (DHW)
► Press input button

Selection of the program

If the switching time programs P2 and P3 have been enabled (see
"System Parameter" menu, program parameter = P1 to P3), the
program selection appears.
If switching time programs P2 and P3 are disabled, program
selection is automatically skipped (see "System Parameters"
menu, program parameter = P1).

Selection of day of the week and cycle

Once the program is selected, the first cycle of the first day of the
week (MO 1) and the relevant section in the top time bar flash.
The other cycles are selected by turning the input button
confirmed by pressing the input button

to access the selected circuit.

.
SDC / DHC

in the following

and
EN2H-0221GE51 R0812