Set Speaker Volume; Using The Keypad; Using The Control Panel - Honeywell HX2 User Manual

Set Speaker Volume

The speaker is on the front, above the 2 key.
Speaker volume can be adjusted to a comfortable level for the listener by using the keypad or by changing parameters in the
Volume & Sounds control panel.

Using the Keypad

Note: Volume & Sounds (in Settings | Control Panel) must be enabled before the following key sequences
can adjust the volume.
The volume is increased or decreased one step each time the volume key sequence is pressed.
To adjust speaker volume:
Blue+Up Arrow and Blue+Down Arrow keys on the Alpha Mode 3 Tap keypad.
l
Orange+Diamond 1+Up Arrow and Orange+Diamond+Down Arrow keys on the Dual Alpha and Triple-Tap
l
keypads.
Press any key, except the keys you used to adjust the volume, to exit.
l
Volume control using a keypad key press has six volume settings that match those supported by the Volume and Sounds
Control panel. Volume does not "roll-over" from minimum to maximum or from maximum to minimum. Continuously holding
down the up or down arrow keys does not cause an automatic repeat of the up (or down) arrow key.

Using the Control Panel

Tap Start | Settings | Control Panel | Volume & Sounds | Volume tab. Change the volume setting and tap OK to save the
change.
You can also select / deselect sounds for key clicks and screen taps and whether each is loud or soft.
As the volume scrollbar is moved between Loud and Soft, the HX2 emits a tone each time the volume increases or decreases.
2-16