Set Speaker Volume; Using The Keypad; Using The Control Panel - Honeywell HX3 User Manual

Set Speaker Volume

The speaker is on the front, above the white key.
Speaker volume can be adjusted to a comfortable level for the listener by using the keypad or by changing parameters in the
Volume & Sounds control panel.

Using the Keypad

Note: Volume & Sounds (in Settings > Control Panel) must be enabled before the following key sequences can adjust the
volume.
The volume is increased or decreased one step each time the volume key sequence is pressed.
To adjust speaker volume use the Blue+White keys and Blue+Green keys to adjust volume until the speaker volume is
satisfactory.
Volume control using a keypad key press has six volume settings that match those supported by the Volume and Sounds
Control panel. Volume does not "roll-over" from minimum to maximum or from maximum to minimum. Continuously holding
down the up or down arrow keys does not cause an automatic repeat of the up (or down) arrow key.

Using the Control Panel

Note: When the HX3 is connected via ActiveSync to a PC running LXEConnect, the Volume and Sounds option in the
Control Panel can be used to adjust volume.
Tap Start > Settings > Control Panel > Volume & Sounds > Volume tab. Change the volume setting and tap OK to save
the change.
You can also select / deselect sounds for key clicks and screen taps and whether each is loud or soft.
As the volume scrollbar is moved between Loud and Soft, the HX3 emits a tone each time the volume increases or decreases.
Note: Although the HX3 has no display or alphanumeric keypad, HX3 operating system screens can be viewed and
parameters manipulated using LXEConnect and ActiveSync on a connected desktop/laptop computer.
2-12