Configuring System Event Settings - Honeywell HRHM1041 User Manual

90 | Performance Series HQA Digital Video Recorder User Guide

Configuring System Event Settings

There are two types of system events: HDD errors (no disk, disk error, no space) and network
errors (no connection, IP conflict, MAC conflict).
Configuring HDD Event Settings
To configure HDD event settings
1.
2.
3.
4.
5.
www.honeywell.com/security
Go to Main Menu > Setting > Event > Abnormality > HDD.
On the HDD tab, in the Event Type box, select the event type that you want to configure
settings for: No Disk, Disk Error, Disk No Space.
Select the Enable check box to enable HDD error detection.
Select the actions that you want the system to initiate when the selected event occurs:
• Alarm Out Select the alarm output(s) (1, 2, or 3) that you want to activate. In the
Latch box, specify the amount of time (1–300 s) to delay the alarm
output signal after the HDD event is triggered.
• Show Message Select the check box to enable a pop-up message on your local host PC.
• Alarm Upload Select the check box to enable the system to upload an alarm signal to
the network (including to an alarm center and/or web client).
• Send Email Select the check box to enable the system to send an email notification.
• Buzzer Select the check box to activate a buzzer noise at the DVR.
Click Apply to save your settings.