Installation Manual of Network Cube Camera
NOTE:
1. Please check if all the items on the package list have been included with your camera.
2. Read the following contents carefully before the installation.
3. Make sure that all the related equipment is power‐off during the installation.
4. Check the power supply to prevent any damage caused by mismatching problems.
5. If the product does not operate properly, please contact your dealer or the nearest service
center. Never attempt to disassemble the camera yourself. Users are responsible for any
problem caused by modification or repairing without authorization.
2.1 Camera Description
2.1.1 Camera Physical Description
Serial NO.
1
2
3
4
5
6
7
8
9
Chapter 2 Installation
LINK: Network status LED indicator.
When the network is connected, the LED flickers in green.
Power LED indicator, which turns red when power is applied to the unit
ETHERNET: 10M / 100M self‐adaptive Ethernet interface
RESET: Reset all parameters to factory default settings
Description
Microphone hole
Micro SD card solt
Lens
Speaker hole
Power supply
2