PLEASE READ THIS FIRST BEFORE OPERATING THIS PRODUCT WHERE TO USE YOUR XG-565: This product does not conform to Federal Motor Vehicle Standards and is not intended for operation on public streets, roads or highways. Serious injury can result from the unsafe operations of this vehicle.
Use only parts and accessories that are recommended by the manufacturer. If a situation arises that is not covered in this manual, Proceed with caution and use good judgment. Contact your dealer or X-Treme (www.x-tremescooters/support) if you need further assistance.
Getting To Know Your A-Blaze Signature Series XG-565 1. Gas/Throttle Lever 13. Choke 2. Front Brake Lever 14. Belt Cover and Mud Guard 3. Rear Brake Lever 15. Handlebar Down Tube 4. Gearshift – NOT ON THIS MODEL 16. Pull Starter 5.
PACKAGE CONTENTS Your X-Treme™ A-Blaze Signature Series XG-565 Gas Scooter comes with the following items in the box: Please locate all of the following: 1. The XG-565 Gas Scooter 2. Allen Wrench 3. Owner’s Manual GETTING STARTED Please read and understand these instructions and the OPERATING PROCEDURES section...
Page 7
8.) Slowly open the GAS CAP, so that possible over pressure disappears. 9.) Clean the tank cap area to make sure that it is free from excess dirt and debris. 10.) Pour pre-mixed Gas/Oil mixture into the GAS TANK. Tank capacity is 0.9 liters.
21.) Control your speed by pressing and releasing the gas lever. The harder you squeeze, the faster you will go. Changing Gears 22.) As max RPM is achieved, second gear can be selected by pressing (a). The return to first gear; press (b) (Fig. 7). Braking 23.) To brake, release the GAS LEVER and gently press either BRAKE LEVERS (Fig.
Always mix fuel and oil in a separate clean, gas safe container. Always start by adding half the amount of fuel which is to be used. Then add the whole amount of 2- cycle oil. Mix (shake) the fuel container. Add the remaining amount of fuel. Mix (shake) the fuel oil thoroughly before filling the tank.
MAINTENANCE RECOMMENDED TOOLS To adjust and service the A-Blaze Signature Series XG-565 Gas Scooter you will need the following tools: Allen Keys: 3/4/5/6mm Wrenches: 10/13/17mm – Open and Ring Combination Short Reach Spark Plug Socket Water Pump Pliers ...
It is a good idea to occasionally clean the air filter to ensure optimum performance. (Replacement of Air filter with anything other than the X-Treme™ replacement parts will automatically void warranty) 1.) Using a Philips head screwdriver, remove the carburetor cover by turning the cover screw counter-clockwise (Fig.
Tire war will differ based on rider weight, riding conditions and care. Replacement tires can be obtained by visiting the X-Treme Website or contacting a representative by phone. Tire Pressure The tire must be inflated to a maximum of 2.5 Bar. It is also recommended to use a tube additive like Slime®...
**DO NOT OVER TIGHTEN OR IT WILL DAMAGE THE BEARINGS!! **DO NOT CONTINUE TO USE PRODUCT IF THERE IS TOO MUCH FREE PLAY AS THIS WILL DAMAGE THE BEARINGS!! ADJUSTING THE BELTS The belts will come adjusted from the factory. However, it may be necessary to adjust the pulleys from time to time.
Check the tires and brakes. WARRANTY AND TECHNICAL SUPPORT X-Treme Scooters offers a 90-day limited bumper-to-bumper manufacturers warranty on all A-Blaze Signature Series XG-565 Gas Scooters that are purchased from an authorized dealer or direct. Original purchase receipt required.
Page 15
This warranty does not include improper fuel or engine oil mixture or attempted repair by any other than a facility authorized by X-Treme to service this product. If you need technical support, contact a technician at www.x-tremescooters.com/support. If you are in need of replacement parts for your XG-565, please visit our site at...
Page 16
DO NOT RETURN TO STORE! IF YOU NEED HELP, CALL (253) 777-0690 OR GO ONLINE TO www.x-tremescooters.com/support Revised 3/27/12...