Adjusting The Fastening Torque - Makita BHP460 Instruction Manual

1. Action mode changing ring
2. Arrow
2
1. Graduations
2. Adjusting ring
3. Arrow
ASSEMBLY
12
CAUTION:
• Always set the speed change lever fully to the correct
position. If you operate the tool with the speed change
lever positioned halfway between the "I" side and "II"
side, the tool may be damaged.
• Do not use the speed change lever while the tool is
running. The tool may be damaged.
Selecting the action mode
002419
This tool employs an action mode changing ring. Select one
of the three modes suitable for your work needs by using this
ring.
For rotation only, turn the ring so that the arrow on the tool
1
body points toward the
2
For rotation with hammering, turn the ring so that the arrow
points toward the
For rotation with clutch, turn the ring so that the arrow points
toward the
CAUTION:
• Always set the ring correctly to your desired mode mark.
If you operate the tool with the ring positioned halfway
between the mode marks, the tool may be damaged.

Adjusting the fastening torque

002426
The fastening torque can be adjusted in 16 steps by turning
the adjusting ring so that its graduations are aligned with the
arrow on the tool body. The fastening torque is minimum
1
when the number 1 is aligned with the arrow, and maximum
when the number 16 is aligned with the arrow.
3
Before actual operation, drive a trial screw into your material
or a piece of duplicate material to determine which torque
level is required for a particular application.
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
mark on the ring.
mark on the ring.
mark on the ring.