ENE048-1 determined according to EN60745: Intended use The tool is intended for grinding, sanding and cutting of Model GA7020,GA7020S metal and stone materials without the use of water. Work mode : surface grinding with normal side ENF002-2 Power supply...
Page 3
Makita declares that the following Machine(s): Designation of Machine: Model GA7021 Angle Grinder Work mode : surface grinding with normal side Model No./ Type: GA7020, GA7020S, GA7021, GA9020, grip GA9020S Vibration emission (a ) : 5.0 m/s Conforms to the following European Directives: h,AG Uncertainty (K) : 1.5 m/s...
Page 4
Electrical safety 16. Dress properly. Do not wear loose clothing or Power tool plugs must match the outlet. Never jewellery. Keep your hair, clothing, and gloves modify the plug in any way. Do not use any away from moving parts. Loose clothes, adapter plugs with earthed (grounded) power jewellery or long hair can be caught in moving parts.
GEB033-7 protectors, gloves workshop apron capable stopping small abrasive GRINDER SAFETY WARNINGS workpiece fragments. The eye protection must Safety Warnings Common for Grinding, Sanding, be capable of stopping flying debris generated by Wire Brushing, or Abrasive Cutting-Off Operations: various operations. The dust mask or respirator This power tool is intended to function as a must be capable of filtrating particles generated grinder, sander, wire brush or cut-off tool.
Page 6
movement at the point of pinching. Abrasive wheels Flanges for cut-off wheels may be different from may also break under these conditions. grinding wheel flanges. Kickback is the result of power tool misuse and/or f) Do not use worn down wheels from larger incorrect operating procedures or conditions and can be power tools.
Page 7
Safety Warnings Specific Wire Brushing 32. Do not use the tool on any materials Operations: containing asbestos. a) Be aware that wire bristles are thrown by the 33. When use cut-off wheel, always work with the brush even during ordinary operation. Do not dust collecting wheel guard required by domestic regulation.
To start the tool, push in the lock lever (in the A FUNCTIONAL DESCRIPTION direction) and then pull the switch trigger (in the B direction). Release the switch trigger to stop. For tool with the lock on and lock-off switch CAUTION: Always be sure that the tool is switched off and To prevent the switch trigger from accidentally pulled, a...
When using an abrasive cut-off / diamond wheel, • Installing or removing depressed center be sure to use only the special wheel guard grinding wheel/Multi-disc (accessory) designed for use with cut-off wheels. (In some European countries, when using a diamond wheel, 1.
Mount the rubber pad onto the spindle. Fit the disc on Operation with wire cup brush the rubber pad and screw the lock nut onto the spindle. (optional accessory) To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench CAUTION: and securely tighten clockwise.
Thread wire wheel brush onto spindle and tighten with For Australia and New Zealand the wrenches. Installing or removing abrasive cut-off wheel / When using wire wheel brush, avoid applying too much diamond wheel (optional accessory) pressure which causes over bending of wires, leading to premature breakage.
The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
Page 13
Side grip Wheel guard for Depressed center grinding wheel/Multi-disc / Wire wheel brush Inner flange / Super flange *1*2 Depressed center grinding wheel/Multi-disc Lock nut / Ezynut *1*2 Wheel guard for Abrasive cut off wheel / Diamond wheel Inner flange 78 (Australia and New Zealand only) Abrasive cut off wheel / Diamond wheel Outer flange 78 (Australia and New Zealand only) Rubber pad...