Page 1
Angle Grinder MODEL GA7020/GA7020F MODEL GA7020S/GA7020SF MODEL GA9020/GA9020F MODEL GA9020S/GA9020SF 006732 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using.
AC supply. They MAKITA INTERNATIONAL EUROPE LTD. are double-insulated in accordance with European Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 Standard and can, therefore, also be used from sockets 8JD, ENGLAND without earth wire. Responsible manufacturer: Makita Corporation Anjo Aichi Japan...
SAFETY INSTRUCTIONS ENA001-2 WARNING: When using electric tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock and personal injury. Read all these instructions before operating this product and save these instructions. For safe operations: tion and changing accessories.
ADDITIONAL SAFETY RULES ENB031-6 13. Hold the tool firmly. Always use eye and ear protection. Other per- sonal protective equipment such as dust mask, 14. Keep hands away from rotating parts. gloves, helmet and apron should be worn. 15. Make sure the wheel is not contacting the work- Always be sure that the tool is switched off and piece before the switch is turned on.
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Shaft lock 006733 CAUTION: • Never actuate the shaft lock when the spindle is moving. The tool may be damaged.
Page 6
ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing side grip (handle) 006735 CAUTION: • Always be sure that the side grip is installed securely before operation. Screw the side grip securely on the position of the tool as shown in the figure.
Page 7
Super flange Models GA7020F,GA7020SF,GA9020F and 9020SF are standard-equipped with a super flange. Only 1/3 of efforts needed to undo lock nut, compared with conventional type. For Australia and New Zealand 006747 Mount the inner flange onto the spindle. Fit the wheel/disc on the inner flange and screw the lock nut with its protrusion facing downward (facing toward the wheel).
OPERATION WARNING: • It should never be necessary to force the tool. The weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage. • ALWAYS replace wheel if tool is dropped while grinding. • NEVER bang or hit grinding disc or wheel onto work.
Page 9
CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.