Start And Stop Presentation In A Call - Cisco MX200 User Manual

31 Share content

Start and Stop Presentation in a Call

Connect your source
and make sure it is
switched on. Tap Share
(a), then scroll horizontally (b)
to locate the presentation source,
if needed. Once located tap the
required source.
Tap Preview, if you want to check what
you will share before you share it, and
then tap Share to actually start sharing
the content of your source.
Tap the three small dots ( ... ), to acess the menu allowing
you to preview or to share the content of the selected
source.
Your content will now be viewable by all
connected participants. to stop sharing content
tap Stop Sharing, as shown.
About Content Sharing
Your video system supports the
ability to show presentations in a
video call or video conference as
well as outside a call. The latter
ability allows the system to be used
for local presentations in a meeting
room, thus extending the use of the
video system and the room itself.
Note that you may change the layout
of the screen during presentations,
see the next page for more on this.
D1458221 User Guide Cisco TelePresence
Profile Series, Codec C-series, Quick Set C20
SX20 Quick Set, MX200, MX300
Produced: December 2014 for TC7.3
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.