Cisco C20 TelePresence System Administrator's Manual page 53

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents
Cameras Camera [1..1] Gamma Mode
Applies to cameras which support gamma mode. The Gamma Mode setting enables for gamma
corrections. Gamma describes the nonlinear relationship between image pixels and monitor
brightness. The Cisco TelePresence PrecisionHD 720p camera supports gamma mode. The
PrecisionHD 1080p camera does not support gamma mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: Auto is the default and the recommended setting.
Manual: In severe light conditions, you may switch mode to manual and specify explicitly
which gamma table to use by setting the Gamma Level.
Cameras Camera 1 Gamma Mode: Auto
Example:
Cameras Camera [1..1] Gamma Level
By setting the Gamma Level you can select which gamma correction table to use. This setting
may be useful in difficult lighting conditions, where changes to the brightness setting does not
provide satisfactory results. NOTE: Requires the Gamma Mode to be set to Manual.
Requires user role: ADMIN
Value space: <0..7>
Range: Select a value from 0 to 7.
Cameras Camera 1 Gamma Level: 0
Example:
Cameras Camera [1..1] IrSensor
The IR sensor LED is located in the front of the camera and flickers when the IR sensor is
activated from the remote control. Both the Codec C Series and PrecisionHD camera have IR
sensors, and only one of them needs to be enabled at the time.
Requires user role: ADMIN
Value space: <Off/On>
Off: Disable the IR sensor on the camera.
On: Enable the IR sensor on the camera.
Cameras Camera 1 IrSensor: On
Example:
D14637.10 Profile C20 and Quick Set C20 Administrator Guide TC6.1, APRIL 2013.
Introduction Web interface System settings System settings
Cameras Camera [1..1] Mirror
With Mirror mode (horizontal flip) you can mirror the image on screen.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: When the camera is placed upside down the image is automatically mirrored. Use this
setting with cameras that can be mounted upside down, and that can auto detect that the
camera is mounted upside down.
Off: See the self view in normal mode, that is the experience of self view is as seeing
yourself as other people see you.
On: See the self view in mirror mode, that is the self view is reversed and the experience of
self view is as seeing yourself in a mirror.
Cameras Camera 1 Mirror: Off
Example:
Cameras Camera [1..1] Whitebalance Mode
Set the camera whitebalance mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will continuously adjust the whitebalance depending on the camera view.
Manual: Enables manual control of the camera whitebalance. The whitebalance level is set
using the Cameras Camera Whitebalance Level setting.
Cameras Camera 1 Whitebalance Mode: Auto
Example:
Cameras Camera [1..1] Whitebalance Level
Set the whitebalance level. NOTE: Requires the Camera Whitebalance Mode to be set to
manual.
Requires user role: ADMIN
Value space: <1..16>
Range: Select a value from 1 to 16.
Cameras Camera 1 Whitebalance Level: 1
Example:
www.cisco.com — Copyright © 2010-2013 Cisco Systems, Inc. All rights reserved.
53
Administrator Guide
Setting passwords Appendices