Makita 12V 8413D Instruction Manual page 11

Selecting the action mode
This tool employs an action mode changing
ring Select one
of
the three modes suit-
able for your work needs by using this ring
For rotation only, turn the ring so that the
arrow on the tool body points toward the
aoomark on the ring For rotation with
hammering, turn the ring so that the arrow
points toward the +on the ring For rota-
tion with clutch, turn the ring so that the
arrow points toward the
mQ
mark on the
ring
Action moc
changing ri
Arrow
CAUTION:
Always set the ring correctly to your desired mode mark. If you operate the tool with the
ring positioned half-way between the mode marks, the tool may be damaged
Adjusting the fastening torque
The fastening torque can be adjusted in 16
steps by turning the adjusting ring so that
its graduations are aligned with the arrow
on the tool body. The fastening torque is
minimum when the number 1 is aligned
with the arrow, and maximum when the
number 16 is aligned with the arrow.
Before actual operation, drive a trial screw
into your material or a piece of duplicate
material to determine which torque level is
required for a particular application.
Graduations
Arrow
11