NETGEAR Trek PR2000 Quick Start Manual page 11

14. If your computer or WiFi device disconnects from the Trek, reconnect
your computer or WiFi device to the Trek.
Use the Trek in Extender Mode
Use the Trek in extender mode to boosting an existing WiFi signal and
enhancing the overall signal quality over long distances. NETGEAR
recommends that you use the Trek in extender mode when a wireless
device is in a dead zone where the connection to your existing WiFi router
is poor or nonexistent.
WiFi Router
¾ To use the Trek in extender mode:
1. Place your Trek in the same room as your WiFi router.
Note: Proximity to the WiFi router is required only during the initial
setup process.
2. Connect your Trek to a power source and rotate the antenna.
For more information, see
Trek
Set Up Your Trek
11
on page 6.