Operation; Maintenance; Optional Accessories - Makita CC300D Instruction Manual

OPERATION

012363
Hold the tool firmly. Set the base plate on the workpiece
to be cut without the wheel making any contact. Then
turn the tool on and wait until the wheel attains full speed.
Feed water to the wheel by adjusting the water supply
cock to obtain a gentle flow of water. Move the tool
forward over the workpiece surface, keeping it flat and
advancing smoothly until the cutting is completed. Keep
your cutting line straight and your speed of advance
uniform.
For fine, clean cuts, cut slowly. (When cutting glass plate
5 mm thick, cut at about 250 mm/min. When cutting tile
10 mm thick, cut at about 300 mm/min.) Also slow down
as you complete a cut to avoid breaking or cracking the
workpiece being cut.
CAUTION:
Be sure to hold the workpiece firmly down on a
•
stable bench or table during operation.
Do not twist or force the tool in the cut, or the motor
•
may be overloaded or the workpiece may break.
Do not use the tool with the diamond wheel in an
•
upward or sideways position.
The wheel for this tool is a wet-type diamond wheel
•
for glass and tile applications. Be sure to feed water
to the diamond wheel during operation.
If the cutting action of the diamond wheel begins to
•
diminish, dress the cutting edge of the wheel using
an old discarded coarse grit bench grinder wheel or
concrete block. Dress by pressing lightly on the
outer edge of the diamond wheel.
NOTE:
When the battery cartridge temperature is low, the
•
tool may not work to its full capacity. At this time, for
example, use the tool for a light-duty cut for a while
until the battery cartridge warms up as high as
room temperature. Then, the tool can work to its full
capacity.
Make sure that the water supply cock is closed
•
before operation.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Diamond wheels
•
Hex wrench
•
Various type of Makita genuine batteries and
•
chargers
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
9
or attachments
Only use accessory or
are