ENGLISH (Original instructions) SPECIFICATIONS Model CC300D Diamond wheel diameter 85 mm Max. wheel thickness 0.8 mm at 0° 25.5 mm Max. Cutting depth at 45° 16.5 mm Rated speed (n) / No load speed (n 1,400 (min Overall length 300 mm Rated voltage D.C.
Page 3
electric shock. 20. Store idle power tools out of the reach of If operating a power tool in a damp location is children and do not allow persons unfamiliar unavoidable, use a ground fault circuit with the power tool or these instructions to interrupter (GFCI) protected supply.
Page 4
GEB053-4 stopping small abrasive workpiece fragments. The eye protection must be capable of CUTTER SAFETY WARNINGS stopping flying debris generated by various The guard provided with the tool must be operations. The dust mask or respirator must be securely attached to the power tool and capable of filtrating particles generated by your positioned for maximum safety, so the least operation.
Page 5
a) Maintain a firm grip on the power tool and 17. Before using a segmented diamond wheel, position your body and arm to allow you to make sure that the diamond wheel has the resist kickback forces. Always use auxiliary peripheral gap between segments of 10 mm or handle, if provided, for maximum control over less, only with a negative rake angle.
Do not store the tool and battery cartridge in FUNCTIONAL DESCRIPTION locations where the temperature may reach or exceed 50 ゚ C (122 ゚ F). Do not incinerate the battery cartridge even if CAUTION: it is severely damaged or is completely worn Always be sure that the tool is switched off and the •...
012361 tighten the bolt securely. For straight cuts, align the A position on the front of the Use only the Makita wrench to install or remove the • base with your cutting line. For 45° bevel cuts, align the B diamond wheel.
Page 8
Loosen the screw A. Slide the tank holder all the way 1. Inner flange over the motor housing. Position the notch of the tank 2. Diamond wheel holder positions just below the screw head as illustrated. 3. Outer flange Then tighten the screw A. 4.
If you need any assistance for more details regarding workpiece being cut. these accessories, ask your local Makita Service Center. Diamond wheels • CAUTION: Hex wrench •...