Bevel Cutting; Adjusting Depth Of Cut - Makita CC300D Instruction Manual

Adjusting depth of cut

012359
CAUTION:
After adjusting the depth of cut, always tighten the
•
clamping screw securely.
Loosen the clamping screw on the depth guide and move
the base up or down. At the desired depth of cut, secure
the base by tightening the clamping screw.

Bevel cutting

1
012360
Loosen the clamping screw on the bevel scale plate on
the front of the base. Set for the desired angle (0° - 45°)
by tilting accordingly, then tighten the clamping screw
securely.
Sighting
B
012361
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the B
position with it.
1. Clamping screw
2. Depth guide
1
2
1. Clamping screw
2. Bevel scale
plate
2
1. Cutting line
1
A
Switch action
1
2
012362
CAUTION:
Before installing the battery cartridge into the tool,
•
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
Do not pull the switch trigger hard without pressing
•
the lock-off lever. This can cause switch breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool, slide
the lock-off lever and pull the switch trigger. Release the
switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing diamond wheel
2
4
012356
CAUTION:
When installing the diamond wheel, be sure to
•
tighten the bolt securely.
Use only the Makita wrench to install or remove the
•
diamond wheel.
To remove the diamond wheel, press the shaft lock fully
so that the diamond wheel cannot revolve and use the
wrench to loosen the hex bolt counterclockwise. Then
remove the hex bolt, outer flange and diamond wheel.
7
1. Lock-off lever
2. Switch trigger
1. Shaft lock
2. Hex wrench
1
3. Tighten
4. Loosen
3