Advertisement
About the Vehicle Battery Cable
Follow these installation guidelines:
•
•
Replacement Fuse Specifications
Specification
Type
Volts
Amps
Optionally, you can also use one of these replacement fuses:
•
•
•
Assemble the Vehicle Battery Cable
1 Route the battery cable from the power supply to the
2 Cut the battery cable near the battery leaving enough of
3 Strip the battery cable jacket back 31 to 36 cm
Universal Vehicle Power Supply Installation Instructions
The power supply can draw up to 0.25 A, even with no
load. So, for gas-powered vehicles, you also need to
install an On/Off switch with a minimum of 15 A DC rating
or an automatic shut-off device in series with the inline
fuse holder.
Place the fuse link assembly as close to the vehicle
battery as possible to protect the entire power cable and
internal power supply of the computer from catastrophic
short-circuit failure. If the fuse fails for any reason, replace
it with a new fuse.
Note: If the fuse is blowing repeatedly, check the vehicle
power to see if excessive voltage spikes are occurring.
Measure
3AB (0.25 x 1.25 in cartridge fuse)
250 VDC
20 A
10 A to 14 V input
6 A to 36 V input
5 A to 48 V input or higher
vehicle battery.
the cable to reach the battery terminals.
(12 to 14 in).
7
Advertisement
