Table of Contents
Advertisement
Chapter 1. Introducing the Cisco Systems Intelligent
Gigabit Ethernet switch module
The Cisco Systems Intelligent Gigabit Ethernet Switch Module for the IBM
ERserver
®
BladeCenter
unit. This Installation Guide contains information about installing and
configuring the Cisco Systems Intelligent Gigabit Ethernet Switch Module for
the IBM Eserver BladeCenter.
Note: Throughout this document, the Cisco Systems Intelligent Gigabit
Ethernet Switch Module for the IBM Eserver BladeCenter is referred to
as the Gigabit Ethernet switch module. Related documentation also
refers to the Cisco Systems Intelligent Gigabit Ethernet Switch Module
for the IBM Eserver BladeCenter as the IGESM.
For installation details, see Chapter 2, "Installing and removing a Gigabit
Ethernet switch module," on page 13. For additional information, see the
instructions in the BladeCenter documentation.
This module supports Cisco IOS Release 12.1 (22) AY or later.
Note: The illustrations in this document might differ from your hardware.
You can obtain up-to-date information about the BladeCenter and other IBM
server products at http://www.ibm.com/pc/support. Record information
about your Gigabit Ethernet switch module in the following table:
Product name
Serial number
Media access
control (MAC)
address
The product name and serial number are on the identification label on the
Gigabit Ethernet switch module. You will need this information when you
register your Gigabit Ethernet switch module with IBM. The media access
control (MAC) address is on a separate label on the information panel under
the external Ethernet port connectors.
© Copyright IBM Corp. 2005
™
is an I/O module that is installed into a BladeCenter
Cisco Systems Intelligent Gigabit Ethernet Switch Module
for the IBM Eserver BladeCenter
_________________________________________________
_________________________________________________
®
1
Advertisement
Table of Contents
