Table of Contents
Advertisement
4. Define the SOL session on VLAN 3. At the console prompt, type:
config t
vlan 3
state active
exit
int gi0/15
sw trunk allow vlan add 3
int gi0/16
sw trunk allow vlan add 3
end
config t
int gi0/17
switchport trunk allowed vlan remove 3
int gi0/18
switchport trunk allowed vlan remove 3
int gi0/19
switchport trunk allowed vlan remove 3
int gi0/20
switchport trunk allowed vlan remove 3
end
5. To save the configuration, type write.
The management module and the Gigabit Ethernet switch module are ready
for SOL traffic over the specified VLAN.
30
Cisco Systems Intelligent Gigabit Ethernet Switch Module: Installation Guide
Advertisement
Table of Contents
