8-Port 10 Gigabit Ethernet Interface Module (8X10Ge) - Cisco ASR 903 Hardware Installation Manual

Interface Modules
1-port 10 Gigabit Ethernet interface modules are not supported in slots 4 and 5.
Note
For information on supported SFP modules, see
Sheet.
For more information about installing a 1-port 10 GE XFP module, see the

8-port 10 Gigabit Ethernet Interface Module (8x10GE)

Figure 19: 8-port 10 Gigabit Ethernet Interface Module
The high density 8-port 10 Gigabit Ethernet interface module supports eight 10 Gigabit Ethernet ports using
SFP+ transceivers cages on the faceplate.
It does not support XFP transceivers on the ports.
Note
The 8-port 10 Gigabit Ethernet interface module is supported in slot 0 on the router with the A900-RSP3C-200-S
RSP module. Only 6 ports of the 8 are enabled. The ports enabled are 0, 1, 4, 5, 6, and 7.
Use the hw-module subslot command to enable the interface module in slot 0 of the router. Save the
configuration and reload the router to activate the interface module.
To remove the configuration, use no hw-module subslot command.
For information on supported SFP modules, see
Sheet.
For more information about installing a 8x10GE module, see the
Cisco ASR 903 Aggregation Services Router Hardware Installation Guide
30
Cisco ASR 900 Series Aggregation Services Routers Data
Interface Module Installation
Cisco ASR 900 Series Aggregation Services Routers Data
Interface Module
Cisco ASR 903 Router Overview
.
Installation.