Multiple Errors - Cisco Power system Installation Manual

Error Messages on Cisco 2600 Series and Cisco 3620, Cisco 3640, and Cisco 3725 Routers

Multiple Errors

Note
Cisco Redundant Power System Hardware Installation Guide
5-12
LED status:
Two or more of the Cisco RPS LEDs are amber.
Console Error Message:
When an external device console screen displays the Cisco IOS software
•
prompt (
routername>
There is more than one failure with the redundant power systems;
please resolve problems immediately.
The Cisco IOS software checks the condition once every 30 seconds. If the
condition still exists, the error message reappears.
It is not a multiple failure when two or more DC output modules have failed.
• When an external device console screen displays the ROMMON prompt
( ),
rommon#>
The message will vary depending on the mix of failures.
Error Description:
The Cisco RPS has two or more failures of any of the previous types.
SNMP Trap Issued Upon Error:
ciscoEnvMonRedundantSupplyNotification is generated.
The varbinds included are ciscoEnvMonSupplyStatusDescr and
ciscoEnvMonSupplyState.
The value of ciscoEnvMonSupplyState is a warning.
How to Correct Error:
Look at the LEDs on the Cisco RPS front panel to determine the types of failures
that have occurred. Go to the section in
instructions on how to correct it.
If the error message persists, replace the Cisco RPS.
Chapter 5
or )
routername#
Table 5-1
Troubleshooting the Cisco RPS
describing each failure type for
OL-3654-01