Rack-Mounting the Cisco RPS
Attaching Brackets
Note
Cisco Redundant Power System Hardware Installation Guide
2-6
Figure 2-2
Telco Bracket
To install the Cisco RPS in a rack, attach the brackets in one of the following
ways:
With the Cisco RPS front panel forward (see
•
With the Cisco RPS rear panel forward (see
•
•
In a center-mount telco rack (see
Although
Figure 2-3
and
same for 23-inch, 24-inch, and telco brackets.
Figure
2-5).
Figure 2-4
show 19-inch brackets, the procedure is the
Chapter 2
Installing the Cisco RPS
Figure
2-3).
Figure
2-4).
OL-3654-01