Cisco Power system Installation Manual page 53

Chapter 4 Connecting the Cisco RPS
Note
Step 1
Step 2
Step 3
Figure 4-1 Cisco 1516M Hub (HP 10BASE-T Hub-16M) Rear Panel
AC power
connector
OL-3654-01
The Cisco RPS can also be used with the older FastHub 100, 200, and 300 series
hubs.
All hubs can use the one-to-one cable configuration for quasi-redundancy. The
FastHub 400 series also supports the option of connecting the AC power cord for
redundancy with reboot, although this configuration is not recommended. The use of
a Y-cable for full redundancy is not supported.
The HP 10BASE-T Hub-16M does not support redundancy with reboot and does not
support use of the Y-cable for full redundancy.
To connect hubs to the Cisco RPS, perform these steps:
Disconnect the AC power cord on the hub.
Connect one end of the one-to-one cable to the Cisco RPS connector on the hub
rear panel. (For connector locations, see
Connect the other end of the cable to a Cisco RPS rear-panel connector as shown
in Figure 4-3.
Cisco Redundant Power System Hardware Installation Guide
Figure 4-1
RS-232
Serial port
Cisco RPS Reset
connector switch
Connecting Hubs
and Figure 4-2.)
4-3