Operation - RIDGID WD18510 Owner's Manual

SP6733-3 Ridgid WD1851 ES

Operation

WARNING: To reduce the risk of fire, explosion, or damage to Vac:
!
• Do not leave Vac running while unattended - you may fail to notice important signs
indicating abnormal operation such as loss of suction, debris/liquid exiting the
exhaust, or abnormal motor noises. Immediately stop using Vac if you notice these
signs.
• Do not leave Vac plugged in when not in use.
• Do not continue running when float has cut off suction.
• Sparks inside the motor can ignite airborne flammables. Do not operate Vac near
flammable liquids or in areas with flammable gases, vapors, or explosive/airborne
dust. Flammable liquids, gases, and vapors include: lighter fluid, solvent-type
cleaners, oil-based paints, gasoline, alcohol, and aerosol sprays. Explosive dusts
include: coal, magnesium, aluminum, grain, and gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
!
WARNING: To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment. Store indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Unplug Vac before servicing. If your Vac is not working as it should, has missing
parts, has been dropped, damaged, left outdoors, or dropped into water, return it to
an independent service center or call customer service.
• When using an extension cord, use only outdoor-rated cords that are in good
condition. Do not allow the connection to come into contact with liquid.
To reduce the risk of electric shock, this
Vac has a polarized plug (one blade is
wider than the other except 230 volt
models). This plug will fit in a polarized
outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "l".
The symbols used on the switch actuator
are international "On & Off" symbols:
= OFF
11/29/12 3:42 PM Page 10
Familiarize yourself with the accessories
included with the Vac. Each accessory may
be used in various ways for vacuuming
and blowing debris. Here is a list of the
accessories and their uses.
Utility Nozzle - General purpose nozzle for
most vacuuming applications.
Wet Nozzle - Used for wet pickup on
smooth surfaces to pick up liquid and dry
the surface in one stroke.
Car Nozzle - Dry pickup nozzle for car
interiors and most upholstery cleaning.
Extension Wands - These wands can be
connected together and provides
additional length for more reach.
= ON
Dual-Flex™ Locking Hose - Provides
transfer of vacuum or blowing capability to
work site. Provides the means of attaching
extension wands and nozzles.
Crevice Tool - Use to pick up debris in
hard to reach locations.
Muffler/Diffuser - Use to disperse
exhaust air stream while reducing noise.
Insert into blowing port.
10