General; System Set-Up - Kenwood TK-372G Service Manual

TK-372G
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced technicians
f a m i l i a r w i t h s i m i l a r t y p e s o f c o m m e r c i a l g r a d e
communications equipment. It contains all required service
information for the equipment and is current as of the
publication date. Changes which may occur after publication
are covered by either Service Bulletins or Manual Revisions.
These are issued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment
information, the full part identification number should be
included. This applies to all parts, components, kits, or chassis.
If the part number is not known, include the chassis or kit
number of which it is a part, and a sufficient description of the
required component for proper identification.
Unit
Model & TX-RX Unit
destination
K X57-5880-11
K2 X57-5880-16
TK-372G
K3 X57-5880-17
K4 X57-5880-13

SYSTEM SET-UP

Merchandise received
License and frequency allocated by FCC
Choose the type of transceiver
Transceiver programming
Are you using the optional antenna?
NO
Are you using the speaker microphone?
NO
Delivery
2
GENERAL / SYSTEM SET-UP
Display Unit Frequency range
450~470MHz
470~490MHz
X54-3250-10
490~512MHz
403~430MHz
Frequency range (MHz)
TX/RX 450~470
TX/RX 470~490
TX/RX 490~512
TX/RX 403~430
A personal computer (IBM PC or compatible), programming interface (KPG-22),
and programming software (KPG-56D) are required for programming.
(The frequency, TX power HI/LOW, and signalling data are programmed for the transceiver.)
YES
KRA-15
Whip antenna
(Option)
YES
KMC-17 or KMC-21
Speaker microphone
(Option)
PERSONNEL SAFETY
The following precautions are recommended for personnel
safety:
DO NOT transmit until all RF connectors are verified secure
and any open connectors are properly terminated.
SHUT OFF and DO NOT operate this equipment near
electrical blasting caps or in an explosive atmosphere.
This equipment should be serviced by a qualified technician only.
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and alignment
procedures contained within.
Remarks
IF1 : 44.95MHz
LOC : 50.4MHz
RF power Type
4.0W TK-372G K
4.0W
TK-372G K2
4.0W TK-372G K3
4.0W
TK-372G K4