NEC NEAX 2000 IVS Command Manual page 210

COMMAND CODE
40
3. ASSIGNMENT PROCEDURE:
ST + 40YY +
4. DATA TABLE:
(1) Data Assignment for MAT
(a) Purpose of RS-232C port
YY (Note 2)
No. MEANING
18 Purpose of RS-232C port
Note 1: Data assignment for Port 0 is not required because Port 0 is only used for RS-232C.
Note 2: CM40 YY=18 is not required when PN-CP03 is used.
Switch setting on PN-CP03 card is required instead of the YY=18 data assignment.
(b) Attribute Data Assignment for RS-232C port
YY
No. MEANING
01 Data Length
02 Parity Check
03 Kind of Parity
04 Stop Bit
05 DTR signal sent to termi-
nal
06 RTS signal sent to terminal
TITLE:
FUNCTION OF RS-232C INTERFACE CIRCUIT
PORT LOCATION NUMBER
DE +
(0/1)
PORT LOCATION NUMBER
1 Port 1
Note 1
PORT LOCATION NUMBER
0 Port 0
1 Port 1
0 Port 0
1 Port 1
0 Port 0
1 Port 1
0 Port 0
1 Port 1
0 Port 0
1 Port 1
0 Port 0
1 Port 1
ND-45669 (E)
DATA
+ DE + +
(1-4 digits)
SETTING DATA
DATA
0 Built-in MODEM
1 RS-232C
SETTING DATA
DATA
0 7 bit
1 8 bit
0 Effective
1 Ineffective
0 Even parity
1 Odd parity
0 1-Stop Bit
1 2-Stop Bit
0 Low
1 High
0 Low
1 High
CM40
EXE
Initial Data
:
MEANING
Initial Data
:
MEANING
CHAPTER 3
Page 179
Revision 2.0