Mitsubishi 3000GT Service Manual page 730

REAR AXLE eAWD>
excessive
TSB Revision
(3) Apply multipurpose adhesive to the threaded holes of
the drive gear.
Specified adhesive:
3M Stud Locking Part No. 4170 or equivalent
(4) Install the drive gear onto the differential case with the
mating marks properly aligned. Tighten the bolts to the
specified torque in a diagonal sequence.
Press-fit the side bearing inner races to the differential case
by using the special tool.
(1) Using the special tool, temporarily tighten the side bearing
nut until it is in the state just before preloading of the
side bearing.
(2) Measure the final drive gear backlash.
Standard value: 0.11-0.16 mm (.004-.006 in.)
NOTE
Measure at four or more points around the drive gear
circumference.
(3) Using the special tool (MB991 367 and MB991 385), adjust
the backlash to standard value by moving the side bearing
nut as shown.
NOTE
First turn the side bearing nut for loosening, and then
turn (by the same amount) the side bearing nut for
tightening.