Mitsubishi 3000GT Service Manual page 436

INTAKE AND EXHAUST
FRONT
A
Intake manifold
manifold
stud
Cylinder
OJPO024
FRONT
Intake'manifold
0 0 0 0 3 7 0 7
INSTALLATION SERVICE POINTS
Install with gasket protrusions in the position illustrated.
INSTALLATION
Tighten the intake manifold mounting nuts one bank after
the other by the following procedure.
(1) Tighten the nuts in the front bank to 3 to 5 Nm (2.2
to 3.6 ftlbs.).
(2) Tighten the nuts in the rear bank to 12 to 15 Nm (9
to 11 ftlbs.).
(3) Tighten the nuts in the front bank to 12 to 15 Nm (9
to 11 ftlbs.).
(4) Repeat steps (2) and (3) one .more time respectively.
(1) Apply engine oil to the intake monifold mounting stud.
(2) Tighten the intake manifold mounting nuts one bank after
the other by the following procedure.
(1) Tighten the nuts in the front bank to 5 to 8 Nm (4
to 6 ft.lbs.).
(2) Tighten the nuts in the rear bank to 20 to 23 Nm
(14 to 17 ft.lbs.).
(3) Tighten the nuts in the front bank to 20 to 23 Nm
(14 to 17 ft.lbs.).
(4) Repeat Steps (2) and (3) one more time respectively.
INSTALLATION 4992 non turbo model>
Apply lubricant sparingly to the intake manifold mounting nuts.
TSB Revision