FUEL INJECTION - Components
Harness side
connector
On-Vehicle Inspection of MFI
Check for an open-circuit, or a
short-circuit between the rear
bank injector and the engine con-
trol module.
Connector: Disconnected
l
Engine control module con-
l
nector: Disconnected
ACTUATOR INSPECTION
Measurement of Resistance between Front Bank
Terminals
(1) Remove the injector connector.
(2) Measure the resistance between terminals.
Standard value: 13-16 Q [at 20°C (SS'F)]
(3) Install the injector connector.
Measurement of Resistance between Rear Bank
Terminals
the
(1) Remove
(2) Measure the resistance between terminals.
Standard value: 13-16 Q [at 20°C (68"F)]
(3) Install the injector connector.
TSB Revision
injector connector.