Operation - Makita LXMU02 Instruction Manual

012541
Overlap the oval hole in the upper blade with that in the
lower one. Move the shear blades so that the hole in the
base plate of shear blades are positioned in the center of
these overlapped oval holes.
012542
Turn the shear blades upside down and install it so that
the pins on the tool fit in the hole in the shear blades.
Make sure that the shear blades are set in place
securely as far as they reach the base plate.
2
1
012534
Place the undercover so that the symbol
undercover is aligned with the symbol
lever.
012543
Press the undercover down and turn the undercover
clockwise while pressing it down until the symbol
the label is aligned with the symbol
lever (the undercover is completely locked.).
1. Base plate
1
2. Hole in the base
plate of shear
2
blades
3. Oval holes that
are overlapped
3
1. Undercover
2. Locking lever
on the locking
on the locking
1
2
012544
At this time, make sure that the locking lever fits in the
groove in the undercover.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
When the shear blades do not operate properly,
•
there is a poor fit between the blades and crank.
Redo from the beginning.

OPERATION

WARNING:
Keep hands away from blades.
•
CAUTION:
Smear the blade before and once per hour during
•
operation using machine oil or the like.
Avoid operating the tool under the scorching
•
sunlight as much as practicable. When operating
the tool, be careful of your physical conditions.
Hold the tool with one hand. Do not hold the front
•
bulge of the tool as a grip.
on the
012530
Turn the tool on after adjusting the shearing height and
hold it so that the foot of the tool rest on the ground.
Then gently move the tool forward into the area to be
cut.
on
8
1. Groove in the
undercover
2. Locking lever