Communications And Remote Services - Honeywell Lynx Touch 5100 Frequently Asked Questions Manual

FAQ's

Communications and Remote Services

4G support
•
L5100 will support the GSMVLP54G 2G/3G/4G radio
•
L5100 will not support the GSMVLP5 2G only radio
•
L5000 currently supports only the GSMVLP5 2G radio
APL (Advanced Protection Logic)
•
APL Is supported by the L5100
Are External antennas available for the L5100?
•
The GSM-EXT is currently available for adding an external antennas to the GSMVLP5-4G.
Push Content – how often does content get sent
•
Wi-Fi/ILP5 – every 4 hours plus on touching the icon
•
GSM – twice a day, as programmed in TOTAL CONNECT 2.0
Slide Show
•
Slideshow is only available through Total Connect 2.0
•
No slide show through GSM, only over Wi-Fi/iP
•
Slide show images are stored in RAM. If the panel recycles power, then all images will need to be
downloaded again. This automatically happens.
I no longer see my "Dashboard Icon" on the L5100
•
If the panel, no longer sees the WiFi/ILP5 card, or GSM card, the "Dashboard Icon" will not show up.
Why are my automation devices not showing up in Total Connect 2.0?
•
The panel data must be synchronized in order for Total Connect 2.0 to recognize the devices.
Why does "No Translation Found" appear in the Automation Module?
•
This happens when Total Connect 2.0 is polling the panel for status on the enrolled Z-Wave devices.
Return to Table of Contents - 10 - Updated: 11/22/13