Fip-1.N3 During Printing - Dell 2135cn Service Manual

FIP-1.N3 During Printing

Step
Possible causative parts:
SEPARATOR ROLLER ASSEMBLY (PL2.1.5)
ROLL ASSY FEED (PL3.2.4)
ROLL ASSY REGI (PL3.2.9)
ROLL REGI METAL (PL3.2.10)
PHD UNIT (PL4.1.21)
FUSER ASSY (PL6.1.1)
TRANSFER ASSY (PL6.1.7)
DRIVE ASSY SUB (PL7.1.1)
DRIVE ASSY MAIN (PL7.1.2)
FAN (PL10.6.17)
Checking the paper feeding
1 Does the noise arise from the printer when the paper is fed
from the Tray 1?
Checking the paper condition in the Paper Cassette
2
Is the paper dry and recommended paper?
Checking noise when the paper is fed from the Tray 1
3
Does the noise arise from the printer?
Checking the SEPARATOR ROLLER ASSEMBLY in the
Paper Cassette for rotation
4 Remove the Paper Cassette from the printer.
Does the SEPARATOR ROLLER rotate smoothly?
Turning it with your finger.
Checking the ROLL ASSY FEED for rotation
Remove the Paper Cassette from the printer.
Checked by [Digital Output]-[DO-00 and 2F] of the [IOT
5 Diag] on the [Printer] of the diagnosis.
Does the noise arise from this Roller?
NOTE: After checking is completed, turn off DO-2F first,
and then turn off [DO-00].
Checking the paper guide sides setting and paper setting of
SSF
6
Were the paper guide sides of SSF correctly set, and was
the paper correctly inserted into SSF?
Checking the paper condition
7
Is the paper dry and recommended paper?
Checking noise when the paper is fed from the SSF
8
Does the noise arise from the printer?
Checking the Main Motor
Does the noise arise from the printer?
9
Checked by [Digital Output]-[DO-00] of the [IOT Diag] on the
[Printer] of the diagnosis.
Version 1 2008.02.01
Check
1 - 420
Chapter 1 Troubleshooting
Remedy
Yes
Go to step 2. Go to step 6.
Replace the paper
with a new dry and
Go to step 4. recommended
one, then go to
step 3.
Go to step 4. End of work.
Replace the
SEPARATOR
ROLLER
Go to step 5. ASSEMBLY.
(Refer to Removal
2/ Replacement
58.)
Replace the ROLL
ASSY FEED.
(Refer to Removal Go to step 9.
4/ Replacement
56.)
Reset the paper
guide sides, and
Go to step 7. correctly insert the
paper to SSF, then
go to step 7.
Replace the paper
with a new dry and
Go to step 9. recommended
one, then go to
step 8.
Go to step 9 End of work.
Go to step 10. Go to step 16.
No