Mounting Of Handle - Makita EM2500U Instruction Manual

MOUNTING OF HANDLE

CAUTION: Before doing any work on the brush cutter, always stop the engine
and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the brush cutter only after having assembled it completely.
For machines with U Handle models
– Place the handle-fixing metal so that the handle with the control lever will be
positioned on the right (the right-hand grip side) as viewed from the engine
side, and the other handle on the left side.
– Fit the groove of the handle-fixing material to the handle end. Fix provisionally
the attached metal by hexagon socket bolt supplied.
– Adjust the handle to an easy-to-operate position, and tighten securely the
four hexagon socket bolts uniformly on the right and left by Allen wrench.
– Surround the throttle cable (1) which comes from carburetor along the
engine cylinder cover in accordance with the direction which is away from
the operator, and wrap it by waist pad (2) along the opposite side of the pipe
operator.
– Insert the throttle cable (1) of control lever into the clamping slot (3) of lower
splint of handle holder.
CAUTION: After waist pad is packed, the redundant throttle cable close to the
engine side can not be curved which can cause phenomenon of too
high idle speed and the blade can not stop, see right photo.
L
(3)
10
R
(2)
(1)
(1)