Exit Wireless Setup; Customize Thermostat (Installer Setup) - Honeywell RedLINK Installation Manual

RedLINK Installation Guide (EIM)
TM
4

Exit wireless setup

Press CONNECT at the EIM to exit wireless setup (light should stop flashing).
Note: The EIM will automatically exit wireless setup after 15 minutes of inactivity.
Note: If installing more than one thermostat and EIM, you must exit wireless setup
before installing an additional thermostat and EIM.
5

Customize thermostat (installer setup)

Follow the steps below to begin installer setup. At each function screen, press
s or t to change the setting as desired, then press NEXT to advance to the
next function screen.
See tables on pages 9-11 for a description of options for each function.
To begin, press and hold the
until the display changes (about 3 seconds).
Function
1
Done
Back
DONE
Press to save & exit.
69-2091EFS—07
FAN
FAN
and
Setting
0
Next
M28485
buttons
s
M28487
M28488
8
0
Done
Back
Press s or t to change
setting (see tables on pages
9-11).
Press NEXT to display next
function screen.
0
Next
M28486